Honda Transmission Differential Transfer Case Seal Driver - 3D Printed

Designed this seal driver to install the transmission differential seal for the transfer case on Honda V6 transmissions. Fits Honda all wheel drive 6 speed transmissions from 2006-2020. Pilot, Ridg...

Designed this seal driver to install the transmission differential seal for the transfer case on Honda V6 transmissions. Fits Honda all wheel drive 6 speed transmissions from 2006-2020. Pilot, Ridgeline and Crosstour. Should fit most all Acura models as well. Have not tested on Acura yet, will update posting once i do. Sets the seal to the correct depth. Recommend using a rubber mallet on tool when driving seal as this is a plastic tool. Fully 3D Printed in orange PLA+ filament. Message me if you would like it printed in a different color.

Seal driver for the input shaft seal on the Transfer Case can be found here.
https://envisionauto3d.com/products/transfer-case-input-shaft-seal-driver-honda-acura-3d-printed-tool

If you are looking for a plug to stop fluid from leaking out during service work where the transfer case is removed, then check out this plug here.
https://envisionauto3d.com/products/differential-transmission-plug-honda-v6-transmission

Since this is a 3D printed item there may be small discrepancies in the print, this is normal due to the 3D Printing process. These discrepancies do not cause any issues in using the tool. Certain brake cleaners may discolor the print.