J32 J35 J37 Intake Block Off Plate, Honda V6 Intake Plenum Cover - 3D Printed

Designed this tray to block off the intake manifold after removing the intake plenum. Helps keep debris, nuts/bolts & tools from dropping down into the engine. Also serves as a tool and/or part...

Designed this tray to block off the intake manifold after removing the intake plenum. Helps keep debris, nuts/bolts & tools from dropping down into the engine. Also serves as a tool and/or part place holder during service work. This fits most Honda‘s older V6 motors, i will try to list them all (J32A1-3, J35A1-9, J35Z1-8, J37, 98-08 TL, 98-03 CL, 99-17 Odyssey, 02-13 MDX, 05-15 Pilot, 05-12 RL, 06-14 Ridgeline, 08-17 V6 Accord, 09-14 V6 TSX, 10-13 ZDX). Item fully 3D printed. Since it is a 3D printed item there may be small discrepancies in the print, this is normal due to being 3D Printed, these discrepancies do not cause any issues in using the tool. Can do customer color upon request. This item is 3D printed using PLA+ filament. Message me for any other questions. Please note that certain brake cleaners may slightly discolor this item. Brake cleaner does not ruin the print only discolors it. I have found that if you rub clean engine oil into the discolored area it will make it look like new again.

**Update May 2024**
Some in the Honda community would like to have magnets in this plate. Doing a run of magnetic plates to see how popular it is. Plate is fully magnetized and will stick to the side of any flat metal surface. There are 10 bar magnets in the center of the plate that are spaced 12mm apart. Blocked off through the top edge of the plate. Helps hold tools/bolts/feeler gauges in place when placed in the center of the plate.
**

This Plate Does Not Fit These Engines (J35Y4, J35Y5, J35Y6 16+ Pilot, 17+ Ridgeline, 18+ Odyssey, 19+ Passport, 14+ RLX, 14+ MDX, 15-20 TLX or J30A1, 97-03 Odyssey, 97-03 Accord) I have a Separate Listing for this plate. See Below

https://envisionauto3d.com/products/j35-earth-dreams-upper-intake-manifold-cover

**Please Note: The melting temperature of PLA+ is 190°C (374°F). Be careful when placing on a very hot engine as it may cause warping.**