J35 Earth Dreams Lower Intake Manifold Covers

This item is 3D printed using PLA filament. Used to block off the lower intake manifold after removing the intake plenum. Helps keep debris, nuts/bolts & tools from dropping down into the engin...

This item is 3D printed using PLA filament. Used to block off the lower intake manifold after removing the intake plenum. Helps keep debris, nuts/bolts & tools from dropping down into the engine. Also serves as a tool and/or part place holder during service work. Try not to put these on when the engine is hot as it may cause warping. This fits Honda‘s newer V6 Earth Dreams motors (J35Y4, J35Y5, J35Y6 16+ Pilot, 17+ Ridgeline, 18+ Odyssey, 19+ Passport, 14+ RLX, 14+ MDX, 15-20 TLX). Please note that certain brake cleaners may slightly discolor this item. Brake cleaner does not ruin the print only discolors it. I have found that if you rub clean engine oil into the discolored area it will make it look like new again. Item fully 3D printed. Since it is a 3D printed item there may be small discrepancies in the print, this is normal due to the 3D Printing process. These discrepancies do not cause any issues in using the tool. This item takes 10 hours to print. listing is for a set of 2, bank 1 plate and bank 2 plate. Can do customer color upon request. Message me for any other questions

**Please Note: The melting temperature of PLA is 190°C (374°F). Be careful when placing on a hot engine as it may cause warping.**

*Individual port plugs that are heat resistant can be found below*
https://envisionauto3d.com/products/j35-earth-dreams-individual-lower-intake-port-covers-honda-acura-3d-printed